Before following the steps, press the power button with a firm touch for 1 second.

Switch the light off. Ensure that the power cable is firmly in the power pack and base of the light.

Remove the arm from the light.

Check the underside of the arm for damage to the power cable inside the horizontal arm.

Reattach the arm, ensuring that the magnetic connector locks into place and is sat inbetween the two roller bearings.

Switch the light on.

Is the power cord or plug damaged?

Check other household appliances.

Check the light in another socket.

Carefully turn the light on its side.

Ensure the power cord is plugged into the centre of the base.

Carefully lay the cord through the indicated groove ensuring it does not become twisted.

Place the light upright ensuring cord remains in the slot.

Ensure the light is plugged into a wall socket and switched on.

Adjust the intensity slider on the arm of the light.

Unplug the light and leave for 1 minute.

Plug the light in and switch on.

Press the power button on the light.

Remove the arm from the light.

Check the underside of the arm for damage to the power cable inside the horizontal arm.

Slide the roller bearing back, reattach the arm ensuring the arm is sat level and the roller is engaged fully.

Swipe to change the intensity of the light.

Tap to change quickly between intensity levels.

Remove the arm from the light.

Check the underside of the arm for damage to the power cable inside the horizontal arm.

Slide the roller bearing back, reattach the arm ensuring the arm is sat level and the roller is engaged fully.

Remove the arm of the light from the stand.

Turn the arm of the light over so the light is facing the ceiling.

Wipe the light with a lint-free dry cloth.

WARNING: Avoid using chemicals when cleaning the light.

It is important that the light is assembled in the box as shown. Do not remove the transit tape until the light is fully assembled.

Attach the base to the vertical arm of the light.

Attach the base nut to the underside of the base and rotate clockwise to secure in place.

Carefully lay the cord through the indicated groove ensuring it does not become twisted. Plug the power cord into the base of the light.

Slide the roller bearing and insert horizontal arm, ensure the magnetic connector sits between the two roller bearings.

Ensure the two halves of the magnetic connector have made contact.

Remove the transit tape from the light.

Adjust the light as needed.

Swipe to change the intensity of the light.

Tap to change quickly between intensity levels.

The LED head can be positioned directionally in 3 axes.

Only use the heat sink arm to reposition.

Important safety instructions

Please see the attached user guide above.